The Allen-Bradley MicroLogix 1761-L16AWA is a 1000 AC power supply controller. It has 16 points available, 10 of which are AC input points and 6 of which are relay output points. Note that a high-speed I/O is not available with this controller. It comes with an EEPROM memory and a 1K user capacity that saves more than 400 data words or more than 700 instruction words. It can support 40 timers and an average program scan time or Kword of 2 milliseconds and an average I/O scan time of 0.21 milliseconds. It has a total measurement of 5.24 x 2.87 x 3.15 inches and a weight of 1.40 pounds. It comes with LED status, input, and output indicators that monitor the controller’s current condition. The 1761-L16AWA also has a master control relay safety feature that allows quick emergency controller shut down when needed. It also uses an IP20 enclosure. The 1761-L16AWA has a response time of 8 milliseconds at the nominal filter setting and a 20 milliseconds maximum delay for both the ON and OFF states. Its operating temperature is between 32 to 131 Degrees Fahrenheit for horizontal mounting, between 32 and 104 Degrees Fahrenheit for vertical mounting, and its storage temperature is between -40 and 185 Degrees Fahrenheit. Its non-condensing relative humidity ranges from 5 to 95% at the operating temperature range.
Maximum power supply inrush current of the 1761-L16AWA controller is 30 Amps for 8 milliseconds. It has a power supply voltage of 47 to 63 Hertz and 85 to 264 Volts AC with a minimum of 50,000 power cycles. The apparent input power for this controller is 15 VA at 120 Volts AC and 21 VA at 240 Volts AC, while its real input power is 7 Watts at 120 Volts AC and 8 Watts at 240 Volts AC. It also has an isolation of 1500 Volts AC and a line voltage of 120/240 Volts AC. Its radiated RFI suppression is 10 V/m, 27 to 1000 Megahertz, 3 V/m, 87 to 108 Megahertz, 174 to 230 Megahertz, and 470 to 790 Megahertz (IEC801-3). The 1761-L16AWA also comes with a transformer load of 18 VA at 120 Volts AC and of 20 VA at 240 Volts AC. This controller’s operating shock is 10 G and its non-operating shock is 20 G. Its operating vibration is 2.5 G, while its non-operating vibration is around 5 G.